The Communication board needed to be able to communicate with the BMW BSD protocol.
Adds 9 analog, 9 digital input and 3 low side outputs over CAN with this module.
Acceleration sensor with the 0-5V output signal (max 3G)
Wires to MaxxECU IGN output, can be used as ignition amplifier, or to directly drive a NOS solenoid.
REQUIRES to be mounted on a bigger surface to divert heat.
CAN module for MaxxECU to extend the number of Wideband sensors in the system, works on all MaxxECU units. Including connectors, Bosch LSU 4.2 sensor.