Please enable JavaScript to view this site.

MaxxECU online help

Note: Always use our latest software version (currently 1.150), which contains the latest features, fixes and improvements.

 

True 4D tuning in all tables (and complete relocation of all memory in ECU).

Compare maps.

Update to the surface 3D view.

Nitrous control: 6 stage control system.

Nitrous control: All stages can be ON/OFF or PWM controlled (selected for each stage).

Nitrous control: Stages can be controlled by set conditions or digital inputs (actual inputs or internal outputs with additional conditions).

Nitrous control: Ramp back of ignition timing on stage deactivation.

Nitrous control: A fuel-model based "dry" stage system. Just enter the nitrous jet size and the system calculates the required fuel.

Nitrous control: A dedicated "Nitrous timer" to fire sequential stages after the launch. With a hold feature if the driver lifts.

Nitrous control: A comprehensive protection system (which can be disabled).

Faster RealTime Data update (new and faster protocol).

New RealTime Data value: Internal outputs states.

New RealTime Data value: Total engine run time (with possibility to reset).

New RealTime Data value: Time after shift.

Description for each digital input, for easy identification during tuning/logging.

Bugfix: Firmware update dialog sometimes hides behind main window after update.

Bugfix: Timeslip data "xxx" instead of "xx.x".

Bugfix: Log file size with fast shutoff.

Open logfiles automatically after download.

Log the advanced warning system.

Clutch input can now reset Distance counters.

Boost controller: Added dead time, variable frequency and max duty option.

Trim fuel or ignition by table.

Target speed adjustments table to the power management system.

Option added ramp back speed to the extra ignition tables.

Actuator control.

Settings is now sorted in alphabetical order in MTune settings tree.

Pulse output system.

 

 

Release date: 2018-01-26

 

Note: a lot of new settings on the Nitrous system has been added or modified, make sure to check your settings after the firmware update! <-- CRITICAL and MUST BE CHECKED!!!!

Downgrading note: Downgrading from a version 1.109 or above, to version 1.108 or below will corrupt the tune in the ECU. This is because 1.108 does not support the dynamic 4D tables that were added in 1.109. If you still want to do this downgrade, you need to have a tune-file saved from the old version and reload it after after the firmware downgrade.

 

Surface 3D will only work in the first dimension even if an 4D axis is activated, we are working on the Surface 3D update to reflect the 4D changes.